Creating the risk matrix

In order to perform risk analysis, it is necessary to establish a risk matrix. Symalean software allows up to 5 separate settings:

- theGravity*

- theLevel of Exposure*

- theProbability of occurrence of risk*

- theLevel of Risk*

- theReturn of Experiment (or accidentology)*

To make this setting, click on the module'Paramage', and the'Security Management'

A last parameter list'Level level*'will allow you to determine the different levels of risk to appear in the Single Document.

After setting these different lists, the risk matrix will be available in the tab'Matrix of risks'of the functionality'Security risks'of the security module.

Namely:The return of experience is calculated as follows:REX = 1 + [(Number AT with stop x associated coefficient) + (Number AT without stop x associated coefficient) +...

*click on the settings to view the corresponding article

• Related Articles

• Creating a fire permit

  Fire permit management is similar to that of security protocols. Only the content of the form is different and will be described in this user guide. At the level of the register of fire permits, click on the " buttonAdd a fire permit" Complete the ...

• Creating an advanced prevention plan

  Once the tab 'Description' of the completed prevention plan (PDP), return to the form and click on "Launch the signing of the PDP". The following form opens. This is to ensure that recipients and their respective email addresses are correct. If OK, ...

• Evaluate risks

  The risk assessment can be done either by area or by work phase by clicking the buttonassociated. On the Risk Assessment page, there is a first section recalling general information related to the Area or Work Phase. The different fields in this ...

• Assessing chemical risks

  This tab lists the different phases of activity for which chemicals can be used. These are: - Inform the activity phase - Indicate the name of the chemical and define if it is a CDA or RMC. - Inform the means(s) of prevention in place - Assess risk ...

• Add a danger

  To add a danger, click the button"+""located at the top right of the table'Danger-Exhibition'. Complete the different fields: Fields marked with a * must be entered. -No.Ref= Automatic generation of a Danger reference. -Site= Select the site(s) ...